Home
WeighPro Classic WeighPro Wireless
About Contact
Get in Touch

Tell us what you're lifting.

We'll spec the right weighing system for your crane and route you to your nearest approved fitter.

Send an Enquiry

Tell us what you need.

We typically respond within one business day.

Enquiry Received

Thank you — your enquiry has been received. We'll be in touch shortly.

How It Works

From Enquiry to Fully Fitted.

Four steps · Start to finish
01

Tell Us Your Crane

HIAB, Epsilon, Palfinger, Kesla, Cranab, Tajfun or excavator. Every WeighPro kit is bespoke to your machine.

02

Bespoke Kit Built

We match the right link to your crane and the right display for your cab — in-cab or top-seat, hydraulic or wireless.

03

Fitted by an Approved Dealer

Your nearest WeighPro dealer fits the system.

04

Backed by 100% Money-Back Guarantee

500+ units installed worldwide.

Common Questions

Before you ask.

Question not answered here? Email us at info@weighpro.ie and we'll come back within a business day.

Most installations are completed in 2 to 3 days by your nearest approved dealer, depending on your machine and the system you choose.
WeighPro is compatible with all forestry crane brands including HIAB, Palfinger, Epsilon, Kesla, Cranab and Tajfun. Every kit is built bespoke to your machine, with the right link spec for your crane and the right display for your cab. If you’re not sure whether your setup is supported, get in touch and we’ll confirm.
Every WeighPro system is backed by a 100% money-back guarantee. With 500+ units fitted worldwide, performance is the standard.
WeighPro is calibrated once at the point of installation by your dealer using two known weights. After this, no further calibration is required. The system never drifts over time. Recalibration is only needed if the grab or rotator is changed.
WeighPro is spec’d to your application. The standard pressure sensor in the link is 0 to 160 bar, which gives tight accuracy in the normal operating range of a forestry timber crane. For heavier lifting, 250 bar and 400 bar sensors are available. Every system is built to suit the machine it’s going on.
Yes. The WeighPro software is built in-house, so we can adjust display settings, units and configuration to suit your specific requirements. Get in touch and tell us what you need.
The hydraulic link is CE certified for use in Ireland, the United Kingdom and across the European Union.